LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Tahoe PPV >> Repair and Diagnosis >> External Pages >> Different car >> Section 1679 (Engine Mechanical - 6.6L (LMM) - Repair Instructions - Off Vehicle (3 Of 3)) >> Generator and Drive Belt Tensioner Bracket Installation

Generator and Drive Belt Tensioner Bracket Installation

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Generator Mounting Bracket
    GM1334912Courtesy of GENERAL MOTORS CORP.
  1. Install the drive belt tensioner and generator mounting bracket.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the drive belt tensioner and generator mounting bracket bolts. Tighten the drive belt tensioner and generator mounting bracket bolts to 50 N.m (37 lb ft).
    3. Fig 2: View Of Drive Belt Tensioner
    GM1334909Courtesy of GENERAL MOTORS CORP.
  3. Install the drive belt tensioner.
  4. Install the drive belt tensioner bolt and tighten to 50 N.m (37 lb ft).
    5. Fig 3: View Of Electrical Harness Clip Bolts
    GM1334907Courtesy of GENERAL MOTORS CORP.
  5. Install the electrical harness clip bolts and tighten to 10 N.m (89 lb in).
scientia non olet · About LEMON Manuals