Section 38 (Gears, Shafts - Manual Transmission 0A4 (Sedan) (A5 Platform))
WARNING: This page is about a different variant/trim than selected.
- 35 Gears, Shafts
- Description And Operation
- Disassembly And Assembly
- Input Shaft
- Notes
- Removing the Outer Race/Tapered Roller Bearing
- Installing the Outer Race/Tapered Roller Bearing
- Removing the Bearing Inner Race/Taper Roller Bearing
- Installing the Bearing Inner Race/Taper Roller Bearing
- Removing the 4th Gear with the Tapered Roller Bearing and Sleeve
- Removing the 3rd Gear
- Installing 3rd Gear
- Removing the 4th Gear
- Pressing on Sleeve for 5th Gear Needle Bearing
- 5th Gear Synchronizer
- Assembling 5th Gear Locking Collar/Synchronizer Hub
- Installation of Offset Springs -A-
- Output Shaft
- Notes
- Removing the Small Outer Race/Tapered Roller Bearing
- Installing the Small Outer Race/Tapered Roller Bearing
- Removing the Bearing Inner Race/Small Taper Roller Bearing
- Installing the Bearing Inner Race/Small Tapered Roller Bearing
- Removing the Synchronizer and 3rd/4th Gear Locking Collar, 2nd, 3rd and 4th Gears with the Needle Bearing Sleeve and Output Shaft
- Removing the Locking Collar with the Synchronizer Hub and Bearing Mount
- Removing the Bearing Inner Race/Large Tapered Roller Bearing
- Installing the Bearing Inner Race/Large Tapered Roller Bearing
- Installed Position of the Inner Race, the Outer Race and the 1st Gear Synchronizer Ring
- Checking the Inner Race for 1st Gear and 2nd Gear for Wear
- Checking 1st Gear and 2nd Gear synchronizing Ring for Wear
- Disassembling and Assembling Locking Collar and Synchronizer Hub for 1st and 2nd Gears
- Assembly: Locking Collar/Synchronizer Hub for 1st and 2nd Gears together with Locking Pieces that are Hollow on the Inside
- Assembly: Locking Collar/Synchronizer Hub for 1st and 2nd Gears together with Locking Pieces that are not Hollow
- Installed Position: Locking Collar/Synchronizer Hub for 1st and 2nd Gears
- Installing the Locking Collar/Synchronizer Hub for 1st and 2nd Gears
- Installed Position of 2nd Gear Outer Race
- Installed Position: Synchronizer Ring -A- (2nd Gear Inner Race)
- Installed Position: 2nd Gear
- Installing the Sleeve for the 3rd Gear Needle Bearing
- Checking 3rd/4th Gear Synchronizing Ring for Wear
- Disassembling and Assembling Locking Collar and Synchronizer Hub for 3rd/4th Gears
- Assembly: Locking Collar/Synchronizer Hub for 3rd and 4th Gears together with Locking Pieces that are Hollow on the Inside
- Assembly: Locking Collar/Synchronizer Hub for 3rd and 4th Gears together with Locking Pieces that are not Hollow
- Installed Position: Locking Collar/Synchronizer Hub for 3rd and 4th Gears
- Installing the Synchronizer Hub with Locking Collar for 3rd and 4th Gears
- Installing the Sleeve for the 4th Gear Needle Bearing
- Installing the Sleeve for the Needle Bearing/Output Shaft
- Reverse Shaft
- Input Shaft
- Special Tools