Assembling 5th Gear Locking Collar/Synchronizer Hub
WARNING: This page is about a different variant/trim than selected.
-- Slide the locking collar over the synchronizer hub.
The pointed teeth -A- and the shoulder -B- on the synchronizer hub face in the same direction. Recesses for locking pieces in locking collar and synchronizer hub must line up refer to 5th Gear Synchronizer .
-- Insert locking pieces Location: refer to 5th Gear Synchronizer .
-- Install the springs offset by 120° under the tabs -C-. The angled end of the spring must be positioned in front of the locking pieces -arrows-.
NOTE:
Note the location of the springs when using locking pieces with hollow interiors, refer to Installation of Offset Springs -A- .