LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2005 >> Jetta TDI, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 38 (Gears, Shafts - Manual Transmission 0A4 (Sedan) (A5 Platform)) >> 35 Gears, Shafts >> Disassembly And Assembly >> Output Shaft >> Disassembling and Assembling Locking Collar and Synchronizer Hub for 3rd/4th Gears

Disassembling and Assembling Locking Collar and Synchronizer Hub for 3rd/4th Gears

WARNING: This page is about a different variant/trim than selected.
Fig 1: Disassembling And Assembling 1St And 2Nd As Well As 3Rd And 4Th Gear Locking Collar And Synchro-Hub
GWWV35-1142Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

1 -

Spring

Assembly in conjunction with the hollow locking pieces, refer to Assembly: Locking Collar/Synchronizer Hub for 3rd and 4th Gears together with Locking Pieces that are not Hollow .

Assembly in conjunction with locking pieces that are not hollow, refer to Assembly: Locking Collar/Synchronizer Hub for 3rd and 4th Gears together with Locking Pieces that are Hollow on the Inside .

2 -

Locking piece

3 -

Locking collar

4 -

Synchronizer hub

-- Slide the locking collar over the synchronizer hub.

The notches for the locking pieces on the synchronizer hub and locking collar must line up with each other.

scientia non olet · About LEMON Manuals