LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2005 >> Jetta TDI, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 38 (Gears, Shafts - Manual Transmission 0A4 (Sedan) (A5 Platform)) >> 35 Gears, Shafts >> Disassembly And Assembly >> Reverse Shaft >> Removing the Needle Sleeve from the Clutch Housing

Removing the Needle Sleeve from the Clutch Housing

WARNING: This page is about a different variant/trim than selected.
Fig 1: Pulling Needle Bearing Out Of Clutch Housing
GWWV35-1152Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

A -

Counter-support, for example, 22/1

B -

Internal puller 14.5 to 18.5 mm, for example, 21/2

NOTE:

The needle sleeve will get damaged when it removed and must be replaced.

scientia non olet · About LEMON Manuals