LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2005 >> Jetta TDI, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 38 (Gears, Shafts - Manual Transmission 0A4 (Sedan) (A5 Platform)) >> 35 Gears, Shafts >> Disassembly And Assembly >> Output Shaft >> Removing the Synchronizer and 3rd/4th Gear Locking Collar, 2nd, 3rd and 4th Gears with the Needle Bearing Sleeve and Output Shaft

Removing the Synchronizer and 3rd/4th Gear Locking Collar, 2nd, 3rd and 4th Gears with the Needle Bearing Sleeve and Output Shaft

WARNING: This page is about a different variant/trim than selected.
Fig 1: Pressing Off 3rd And 4th Gear Synchro-Hub/Locking Collar, 2nd, 3rd And 4th Gears With Transmission Housing Needle Roller Bearing Sleeve
GWWV35-1222Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

A -

Separating tool 22 to 115 mm, for example, 17/2

B -

M10 x 20, 17 mm bolt

NOTE:

Support the separating tool so that the 1st/2nd gear locking collar does not come off as well.

scientia non olet · About LEMON Manuals