Reverse Shaft: Notes
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Thrust TubeVW 454
- Thrust PadVW 447 H
- PunchVW 411
- Centering Mandrel 12 - 551
- Thrust PlaceVW 401
- PunchVW 408 A
- Kukko Extractor 14.5-18.5 mm21/2
- Kukko Support22/1
NOTE:
Always replace the needle sleeve after removing it from the clutch housing or from the reverse shaft support.
- Clutch Housing
- Needle Sleeve
- Removing, refer to Removing the Needle Sleeve from the Clutch Housing .
- Installing, refer to Installing the Needle Sleeve -A- into the Clutch Housing .
- Reverse Gear
- Lock Ring
- Always replace after removing.
- Reverse Gear
- Remove before replacing the lock ring.
- Collar faces reverse gear.
- Reverse Shaft
- Removing, refer to TRANSMISSION .
- Needle Sleeve
- Removing, refer to Removing the Needle Sleeve from the Clutch Housing .
- Installing, refer to Installing the Needle Sleeve into the Reverse Shaft Support .
- Reverse Shaft Support
- Removing and installing, refer to TRANSMISSION .