Installed Position of the Inner Race, the Outer Race and the 1st Gear Synchronizer Ring
WARNING: This page is about a different variant/trim than selected.
Fig 1: Exploded View Of Modified 1st Gear Synchronization Components (From Transmission Build Date 02 05 0)
-- Place the inner race -A- on the drive gear for 1st gear.
The angled tabs -arrows 1- face the outer race -B-.
-- Install the outer race -B-.
The tabs -arrows 2- must lock into the retainers -arrows 3- in the gear.
-- Install the synchronizer ring -C-.
The retainers -arrows 4- lock in the tabs -arrows 1- on the inner race -A-.
NOTE:
If the parts are not to be replaced, make sure they are reallocated to their original gear.