Assembly: Locking Collar/Synchronizer Hub for 3rd and 4th Gears together with Locking Pieces that are Hollow on the Inside

WARNING: This page is about a different variant/trim than selected.

Fig 1: Assembling 1St And 2Nd As Well As 3Rd And 4Th Gear Locking Collar/Synchro-Hub

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The locking collar is pushed over the synchronizer hub.

-- Install the locking pieces and springs offset by 120°. The angled end of the spring must engage into the hollow locking piece.