Section 89 (Headlight System - With Diagnostics)
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
- Service Specifications
- Special Tools
- Service Precautions < Vehicles With Discharge Headlight >
- Diagnosis
- Diagnostic Trouble Code Procedures
- DTC B16A2: Turn signal (LH) bulb outage
- DTC B16A3: Turn signal (LH) circuit short
- DTC B16A4: Turn signal (RH) bulb outage
- DTC B16A5: Turn signal (RH) circuit short
- DTC B16A6: Turn signal fuse blown
- DTC L0432: RLS RS adaptation error < Vehicles with lighting control sensor >
- DTC L0434: RLS light sensor error < Vehicles with lighting control sensor >; DTC L0436: RLS rain sensor error < Vehicles with lighting control sensor >
- Trouble Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: None of the low-beam headlights illuminate
- Inspection Procedure 2: None of the high-beam headlights illuminate
- Inspection Procedure 3: The headlights (low-beam) illuminate regardless of the lighting switch positions. (High-beam does not illuminate)
- Inspection Procedure 4: The headlights do not illuminate when the passing switch is turned ON
- Inspection Procedure 5: One of the headlight(s) does not illuminate
- Inspection Procedure 6: The high-beam indicator light does not illuminate
- Inspection Procedure 7: The headlight automatic shutdown function does not work normally
- Inspection Procedure 8: The auto light function does not work normally. < Vehicles with lighting control sensor >
- Inspection Procedure 9: The auto light function does not work normally. < Vehicles with LDW >
- Inspection Procedure 10: One of the position lights, the license plate lights or the taillights does not illuminate
- Inspection Procedure 11: None of the turn-signal lights illuminate
- Inspection Procedure 12: The comfort flashing function does not work normally
- Inspection Procedure 13: The turn-signal indicator lights do not illuminate
- Inspection Procedure 14: The welcome light function does not work normally
- Inspection Procedure 15: The coming home light function does not work normally
- DATA LIST REFERENCE TABLE < Vehicles with lighting control sensor >
- On-Vehicle Service
- Headlight Aiming
- Luminous Intensity Measurement
- Replace The Bulb
- Headlight Automatic Shutdown Function Check
- Headlight Auto Light Function Check
- Welcome Light Function Check
- Coming Home Light Function Check
- Customization Function
- LIGHTING CONTROL SENSOR (LIGHT SENSOR) CHECK < Vehicles with lighting control sensor >
- LDW-ECU (LIGHT SENSOR) CHECK < Vehicles with LDW) >
- Headlight Relay Check
- Headlight
- Headlight Leveling Switch < Vehicles With Headlight Manual Levelling System >
- LIGHTING CONTROL SENSOR < Vehicles with lighting control sensor >