DTC B16A6: Turn signal fuse blown: Diagnosis

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

STEP 1. Fuse check
Check if the turn-signal light fuse is normal.

Q: Is the check result normal?
- YES: Go to Step 2.
- NO: Replace the turn-signal light fuse.
STEP 2. Using scan tool (M.U.T.-III), Check whether the diagnostic trouble code is stored again.
CAUTION: To prevent damage to scan tool (M.U.T.-III), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-III).
1. Connect scan tool (M.U.T.-III). Refer to "HOW TO CONNECT SCAN TOOL (M.U.T.-III) ."
2. Erase the DTC.
3. Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
4. Check if DTC is stored.
Q: Is the DTC stored?
- YES: Replace the ETACS-ECU.
- NO: The diagnosis is complete.