Section 52 (Motor Driven Power Steering System Diagnosis (PHEV))
WARNING: This page is about a different car, the 2024 Kia Sorento. However, it is still accessible from the selected car via links, so may be relevant.
- DTC C1101-17: Battery Voltage High
- DTC C1102-16: Battery Voltage Low
- DTC C1109-21: IG1 Open - MDPS Fail Safe
- DTC C1112-01: Sensor Source Voltage
- DTC C1202-86: Wheel Speed Sensor Front-LH Invalid/No Signal
- DTC C1205-86: Wheel Speed Sensor Front-RH Invalid/No Signal
- DTC C1208-86: Wheel Speed Sensor Rear-LH Invalid/No Signal
- DTC C1211-86: Wheel Speed Sensor Rear-RH Invalid/No Signal
- DTC C1259-01: Steering Angle Sensor - Electrical
- DTC C1259-29: Steering Angle Sensor-Electrical
- DTC C1259-38: Steering Angle Sensor-Electrical
- DTC C1259-62: Steering Angle Sensor-Electrical
- DTC C1261-54: Steering Angle Sensor Is Not Calibrated
- DTC C1262-04: Temperature Sensor Failure
- DTC C1290-02: Torque Sensor Signal Fail
- DTC C1603-4B: ECU Thermal Protection
- DTC C1604-04: ECU Hardware Error
- DTC C1606-04: ECU Software Error
- DTC C1611-87: CAN Time-Out EMS
- DTC C1613-86: CAN Signal Error EMS
- DTC C1614-87: CAN Time-Out HCU
- DTC C1616-88: C-CAN Bus Off
- DTC C161C-86: CAN Signal Error HCU/VCU/FCU
- DTC C1628-87: CAN Time-Out Cluster
- DTC C1629-86: Cluster Invalid Counter
- DTC C1633-86: Cluster Invalid Displayed Speed
- DTC C1659-87: CAN Time-Out SAS
- DTC C166B-87: CAN Time-Out Wheel Speed Sensor
- DTC C1692-87: CAN Time-Out ESC
- DTC C1693-86: ESC Signal Error
- DTC C16B2-86: WHL_SPD Checksum/Alive Counter Error
- DTC C16BF-64: WHL_SPD Monitoring Logic Error
- DTC C1700-04: Byte Coding Error
- DTC C1702-55: Variant Coding Error
- DTC C1704-01: ECU Fail-Safe Relay Fail
- DTC C1705-04: ECU Pre-Charge Circuit Fail
- DTC C1711-01: Improper Program Termination
- DTC C1804-87: CAN Time Out LKAS
- DTC C1805-86: LKAS CAN Signal Error
- DTC C1814-83: CAN Message Failure - SAS
- DTC C1814-86: CAN Message Failure - SAS
- DTC C1866-87: CAN Time-Out ICSC
- DTC C2401-62: Motor Circuit
- DTC C2412-16: Motor Short Or Open
- DTC C2412-62: Motor Short Or Open
- DTC C2413-19: Motor Current Fail (Current Over)
- DTC C2413-28: Motor Current Fail (Current Over)
- DTC C2413-96: Motor Current Fail (Current Over)