Front Suspension (Description - Assembly) (4A2 & 4A5)

• 40 Front Suspension
  • Description And Operation
    • SUBFRAME Assembly
  • Specifications
    • Fastener Tightening Specifications
  • Removal And Installation
    • Driveshaft
      • Notes
      • Removing
    • SUBFRAME
      • Notes
      • Removing
      • Installing
    • Suspension Strut
      • Notes
      • Removing
    • Coil Springs
      • Notes
      • Removing
      • Installing
    • Shock Absorber
      • Notes
      • Removing
      • Installing
  • Disassembly And Assembly
    • Driveshaft, Manual Transmission
      • Notes
      • Fig. 1 Pressing off inner CV joint
      • Fig. 2 Installing inner CV joint
      • Fig. 3 Tightening clamps
      • Fig. 4 Ventilating CV joint boot
      • Fig. 5 Removing outer CV joint
      • Fig. 6 Installation position of dished washer, spacer washer and circlip
    • Driveshaft, Automatic Transmission
      • Notes
      • Fig. 1 Tightening clamps
      • Fig. 3 Ventilating CV boot
      • Fig. 4 Pulling boot over splined shaft bead
      • Fig. 5 Installation position for dished washer, spacer washer and circlip
    • Front Suspension
      • Notes
      • Fig. 1 Removing and installing inner control arm bushing
      • Fig. 2 Aligning control arm bushing to control arm
      • Fig. 3 Installation position of control arm bushing in control arm
      • Fig. 4 Removing front subframe bushing
      • Fig. 5 Installing front subframe bushing
      • Fig. 6 Installing extractor in rear subframe bushing
      • Fig. 7 Removing rear subframe bushing
    • Suspension Strut
      • Notes
      • Fig. 1 Pressing out wheel hub
      • Fig. 2 Pressing in wheel hub
      • Fig. 3 Pressing out wheel bearing
      • Fig. 4 Removing bearing inner race
      • Fig. 5 Installing wheel bearing
      • Fig. 6 Removing and installing threaded cap
      • Fig. 7 Tightening top nut with torque wrench
      • Fig. 8 Modified wheel hub for S4/S6 models
  • Special Tools