Section 159 (Axle Shafts - Removal & Installation (Coupe))
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
- Driveline/Axles
- Drive Shaft, Removing From Viscous Coupling
- Drive Shaft, Left, Installing
- Notes
- Transmission, installing
- Notes
- When replacing with a new transmission
- Checking before installing
- Adjusting the position of the transmission and engine
- Installing and tightening the screws for the transmission
- Installing the splash guard above the transmission
- Installing the heated oxygen sensor (HO2S) connectors on the bracket on the transmission
- Lifting the engine and transmission to the horizontal position
- Installing the oil pipe at the transmission
- Installing the rear engine mounting
- Installing the engine pad
- Installing the engine pad on the engine mounting
- Installing the sub-frame on the bodywork
- Installing the screw for the rear engine pad through the steering gear
- Installing the collision protection system over the steering gear
- Installing the drive shaft and the viscous coupling
- Installing the right-hand drive shaft on the transmission, wheel spindle and control arm
- Installing and tightening the sub-frame screws
- Installing the screws for the bracket for the heated oxygen sensor (HO2S) cable
- Installing the front cross member
- Installing new lock nuts on the steering gear
- Installing the screw for the front engine pad and the torque rod mounting in the transmission
- Installing the screws for the cable ducts and ground lead bracket
- Installing and tightening front end components (both sides)
- Tightening the ball joint pinion
- Remove the lifting beam and the lifting hook from the engine and the vehicle
- Installing the torque converter screws
- Installing the clamp for the oil pipe
- Installing the charge air hose
- Installing the screws in the transmission and engine
- Installing the starter motor
- Installing the dip stick pipe in the transmission
- Installing engine compartment components
- Installing the hose for the heater pipe
- Installing the gear selector cable on the transmission and lever
- Installing the upper torque rod
- Installing the air cleaner (ACL) housing
- Finishing work
- Filling the transmission with fluid
- Filling with transmission oil. There are 2 different methods. Method 1
- Filling with transmission oil. Method 2
- Check the coolant level in the expansion tank
- Installing the splash guards and the fender liner
- Assembling the upper and lower steering shaft
- Checking the Steering Gear Bearing In the Boot At the Firewall
- Installing the Battery Lead
- Programming the Transmission Control Module (TCM)
- Test driving the vehicle