Installing the screws in the transmission and engine

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Transmission, Starter Motor And Ground Lead Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the 3 screws for the transmission and engine. Tighten to 50 Nm
the ignition setting sender and the screw. Tighten to 10 Nm
the screw for the clamp for the positive cable. Tighten to 10 Nm .