LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2003 >> C70 2.3 53, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 159 (Axle Shafts - Removal & Installation (Coupe)) >> Driveline/Axles >> Drive Shaft, Left, Installing >> Transmission, installing >> Checking before installing

Checking before installing

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Flushing clean the oil cooler 

When replacing the transmission, the oil cooler must always be flushed clean because there may be particles in the oil cooler. See Oil cooler, flush cleaning .

Fig 1: Transmission And Engine Mating Surfaces
GLL109291Courtesy of VOLVO CARS OF NORTH AMERICA.

Check that the transmission and engine mating surfaces are absolutely  clean.

Also check that the guide sleeves towards the engine are in position and are free of faults.

Lubricate the holes in the transmission (for the guide pins). Use a little grease.