Installing the upper torque rod

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Torque Rod And Mounting Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the engine stabilizer brace. Tighten the mounting screws. Tighten to 50 Nm
the screw and a new nut for the engine mounting. Tighten to 80 Nm
the plastic guard over the spring strut (if applicable). Tighten the screws.