Section 19 (Heater, Air Conditioning And Ventilation - Lancer Evolution)
WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
- General Information
- Fastener Tightening Specifications
- General Specifications
- Service Specifications
- Lubricants
- Service Precautions
- Auto A/C Diagnosis
- Introduction To Heater, A/C And Ventilation Diagnosis
- Heater, A/C And Ventilation Diagnostic Troubleshooting Strategy
- Diagnostic Function
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC B10C0, B10C1: Interior Temperature Sensor System
- DTC B1000: Control Panel Communication Error
- DTC B1003: Mode Dial SW Error
- DTC B1018: Temperature Control Dial SW Error
- DTC B1021: Fan Dial SW Error
- DTC B1031, B1032: Fin Thermo Sensor System
- DTC B1034, B1035: Ambient air temperature Sensor System
- DTC B1079: Refrigerant Leaks
- DTC B2214: Control Panel Failure
- DTC B223B: Control Panel Improperly Assembled
- DTC U1415: Coding Not Completed
- DTC U0019: Bus Off (CAN1)
- DTC U0141: ETACS-ECU Time-out
- DTC U0151: SRS-ECU Time-out
- DTC U0154: Occupant classification ECU time out
- DTC U0155: Combination meter Time-out
- DTC U0168: WCM Time-out
- DTC U0184: Audio Time-out
- DTC U0195: Satellite radio tuner CAN timeout
- DTC U0197: Hands Free Module Time-out
- DTC U0245: Audio visual navigation unit CAN timeout
- Symptom Chart
- Symptom Procedures
- INSPECTION PROCEDURE 1: When the A/C is Operation, Temperature Inside the Passenger Compartment does not Decrease (Cool Air is not Emitted)
- INSPECTION PROCEDURE 2: Malfunction of the A/C-ECU Power Supply System
- INSPECTION PROCEDURE 3: The Compressor does not Work
- INSPECTION PROCEDURE 4: Blower Fan and Motor do not Turn
- INSPECTION PROCEDURE 5: Blower Air Amount cannot be Changed
- INSPECTION PROCEDURE 6: Outside/Inside Air Changeover is not possible
- INSPECTION PROCEDURE 7: A/C Outlet Air Temperature does not Increase
- INSPECTION PROCEDURE 8: Air Outlet Vent cannot be Changed
- INSPECTION PROCEDURE 9: Blower Motor power supply system
- Data List Reference Table
- Actuator Test
- Check At A/C-Ecu Terminal
- Special Tools
- On-Vehicle Service
- Heater Control Unit
- Heater Unit And Blower Assembly
- Motors And Transistor
- Ambient Temperature Sensor
- Interior Temperature Sensor
- A/C-Ecu
- Compressor Assembly And Tension Pulley
- Condenser Assembly
- Refrigerant Line
- Ducts
- Ventilators