Special Tools

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

SPECIAL TOOLS DESCRIPTION CHART

Tool	Tool number and name	Supersession	Application
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.	MB991367 Special spanner	MB991367-01	Armature mounting nut of compressor removal and installation
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.	MB991386 Pin	MIT217213	Armature mounting nut of compressor removal and installation
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.	MB991658 Test harness set	Tool not available	Inspection of throttle position sensor
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.	MB991223 MB991219 MB991220 MB991221 MB991222	Harness set Check harness LED harness LED harness adapter Probe	Continuity check and voltage measurement at harness wire or connector For checking connector pin contact pressure For checking power supply circuit For checking power supply circuit For connecting a locally sourced tester
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.	MB992006 Extra fine probe	General service tool	Making voltage and resistance measurement during troubleshooting
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.	MB991955 MB991824 MB991827 MB991910 MB991911 MB991825 MB991826	M.U.T.-III sub-assembly Vehicle Communication Interface (V.C.I.) M.U.T.-III USB cable M.U.T.-III main harness A (Vehicles with CAN communication system) M.U.T.-III main harness B (Vehicles without CAN communication system) M.U.T.-III measure adapter M.U.T.-III trigger harness	CAUTION: For vehicles with CAN communication, use M.U.T.-III main harness A to send simulated vehicle speed. If you connect M.U.T.-III main harness B instead, the CAN communication does not function correctly. A/C-ECU check (Diagnosis code, service data, actuator test)