Section 559 (Information Center [Instrumentation/Driver Info])

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Instrumentation/Driver Info. Location Index
- Interior
- Exterior
Instrument Cluster Removal/Installation
Instrument Cluster Configuration
Instrument Cluster Disassembly/Assembly
Instrument Cluster Inspection
- Speedometer
  - Using a speedometer tester
  - Using the M-MDS
- Tachometer
- Fuel gauge
- Water temperature gauge
Instrumentation/Driver Info. Personalization Features Setting Procedure
- Instrument Cluster
- Blind Spot Monitoring (BSM) System
Info Switch Removal/Installation
Info Switch Inspection
Fuel Gauge Sender Unit Removal/Installation
Fuel Gauge Sender Unit Inspection
Oil Pressure Switch Inspection
Horn Removal/Installation
Information Display Removal/Installation
Information Display Input/Output Check Mode
- Notes
- Check Code Table
- Check Code Inspection
Blind Spot Monitoring (BSM) Control Module Removal/Installation
Blind Spot Monitoring (BSM) Control Module Inspection
- Notes
- Terminal Voltage Table (Reference)
Blind Spot Monitoring (BSM) Bracket Removal/Installation
Blind Spot Monitoring (BSM) Radar Test
- Introduction
- Radar Test Procedure
Blind Spot Monitoring (BSM) Off Switch Removal/Installation
Blind Spot Monitoring (BSM) Off Switch Inspection