Section 145 (Half Shafts, Hubs, Wheel Spindles - Specifications, Removal & Installation (Coupe))
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
- Driveline/Axles
- Constant Velocity Joint, Greasing And Installation
- Drive Shaft, Front Left, Replacing
- Notes
- Preparatory work
- Removal
- Removing the ball joint from the control arm
- Removing the ball joint from the control arm, continued
- Removing the Drive Shaft From the Wheel Hub
- Applies From Chassis No. 1354476-
- Removing the splash guard under engine
- Draining transmission fluid
- Removing the Drive Shaft From the Transmission
- Removing the Drive Shaft From the Transmission, Continued
- Installation
- Finishing
- Drive Shaft Nut, New
- Half Shaft, Left, Replacing (For 4T65 1999-)
- Half Shaft, Left, Replacing (For M65 1999-)
- Half Shaft, Left, Replacing (For AW55-50 and AW50AWD 2001-)
- Half Shaft, Right, Replacing (For M56 and M58 2000-)
- Half Shaft, Right, Replacing (For M56 and M58 2001-)
- Half Shaft, Right, Replacing (For M65 1999-)
- Rear Wheel Hub, Measuring Lateral Runout
- Wheel Spindle, Removing From Control Arm
- Wheel Spindle, Left-Hand Side, Preparatory Work For Removing