Removing the ball joint from the control arm

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Drive Shaft Nut And Lower Ball Joint Nut

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove:

the wheel
the screw for the drive shaft. Counterhold using a screwdriver in the brake disc vents. Tap/press the end of the drive shaft into the hub approximately 20-25 mm
the nut for the ball joint/control arm. If the ball joint pinion moves, counterhold the end of the lug. Use a Torx wrench.