LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2003 >> C70 2.3 53, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 145 (Half Shafts, Hubs, Wheel Spindles - Specifications, Removal & Installation (Coupe)) >> Driveline/Axles >> Half Shaft, Left, Replacing (For 4T65 1999-) >> Removal >> Remove the Drive Shaft From the Transmission

Remove the Drive Shaft From the Transmission

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing Drive Shaft From Transmission Using Jimmy Tool 999 5736
GLL109282Courtesy of VOLVO CARS OF NORTH AMERICA.

Use jimmy tool 9995736 .

Position the two jimmy tools opposite each other.

Detach the drive shaft.

NOTE: Pull the constant velocity joint  , not the drive shaft joints, when removing the drive shaft. There is no axial pinion.
NOTE: Take care not to damage the drive shaft when removing it from the transmission.

Install plug 9995730 on the transmission.

Fig 2: Identifying Rubber Seal On Constant Velocity Joint
GLL106610Courtesy of VOLVO CARS OF NORTH AMERICA.
CAUTION: Later models have a rubber seal on the constant velocity joint. Do not damage the seal. It will be needed for installation.
scientia non olet · About LEMON Manuals