Removing the ball joint from the control arm, continued
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Disconnect the ball joint pinion from the control arm. Use tool 9997062 .
Install cap nut 7062-1 on the ball joint pinion. Tighten the nut against the control arm. Then turn back one turn to form a gap between the cap nut and the control arm.
Position the extractor on the control arm. Detach the ball joint from the control arm.