Section 70 (Transmission - Inspection, Removal & Installation)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
- Transmission Cable
- Transmisson Check
- Transmission Fluid
- Transmission Installation
- Transmission, installing
- Notes
- Checking before installing
- Adjusting the position of the engine and transmission
- Installing and tightening the screws for the transmission
- Installing the dip stick pipe and oil hose on the oil cooler. Install the 3 screws for the transmission
- Installing the torque converter screws
- Installing components on the sub-frame
- Lifting the engine and transmission to the horizontal position
- Installing the rear engine mounting
- Installing the sub-frame on the bodywork
- Installing the left drive shaft on the transmission, wheel spindle and control arm
- Installing the engine stabilizer brace
- Installing the exhaust pipe on the turbocharger (TC) and the starter motor on the engine
- Installing the right drive shaft on the transmission, wheel spindle and control arm
- Installing and tightening the sub-frame screws
- Installing and tightening front end components (both sides)
- Tightening the ball joint pinion
- Installing a new screw and new lock nuts for the steering gear
- Removing the tie strap from the steering gear
- Installing and tightening the screw for the rear engine pad
- Installing the delivery line on the rubber hoses
- Installing the front cross member
- Installing the screw for the ground lead and cable conduit
- Lowering the car and removing the lifting beam and lifting tools from the engine
- Installing the remaining screws for the transmission and starter motor
- Installing the torque control arm
- Installing the transmission cable bracket on the transmission and the cable on the lever
- Installing the air hose on the turbocharger (TC) and the delivery line on the manifold
- Installing the upper torque rod in the engine compartment
- Installing the air cleaner (ACL) housing and engine cover
- Checking the transmission fluid level
- Transmission, installing