Installing and tightening the sub-frame screws

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Sub-Frame And Bolts

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the screws for the support bracket, both sides.

First tighten the screws on the left-hand side of the frame, followed by the right-hand side, to 105 Nm + 120° . Use a bevel protractor 9512050 .

Then tighten the screws for the frame brackets. Tighten to 50 Nm .