Installing the right drive shaft on the transmission, wheel spindle and control arm

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Drive Shaft At Transmission

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE:

Take care not to damage the drive shaft seal in the transmission.

Install the drive shaft pilot bearing cover

Tighten with 25 Nm .

Align the drive shaft in the wheel arch. Install a new screw loosely in the drive shaft.

Install:

the mobile jack under the sub-frame. Remove both the sub-frame screws. Lower the sub-frame approximately 10 cm
the wheel spindle on the control arm
the lock nut loosely.

Lift the sub-frame to the bodywork. Install the frame screws.

Press the evaporator cable and the oil pipe into place in the sub-frame clips.