Installing the exhaust pipe on the turbocharger (TC) and the starter motor on the engine

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exhaust Pipe To Turbocharger And Starter Motor Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the exhaust pipe on the turbocharger (TC). Use two new nuts. Tighten to 25 Nm
the starter motor and the screw. Tighten to 40 Nm
the cable on the starter motor and the nut. Tighten to 20 Nm
the control cable for the solenoid.

Tighten the transmission screw. Tighten to 25 Nm .