LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 200 (Air Conditioning) >> BLOWER UNIT (for Sedan) >> Installation

BLOWER UNIT (for Sedan): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL BLOWER UNIT 
    1. Install the blower unit with the 3 screws.
  2. INSTALL INSTRUMENT PANEL REINFORCEMENT (See INSTALLATION  )
  3. INSTALL CONNECTOR NO. 2 HOLDER (See INSTALLATION  )
  4. INSTALL MAIN BODY ECU (DRIVER SIDE J/B) (See INSTALLATION  )
  5. INSTALL INSTRUMENT PANEL BRACE SUB-ASSEMBLY (See INSTALLATION  )
  6. INSTALL REAR NO. 3 AIR DUCT (for Cold Area Specification Vehicles) (See INSTALLATION  )
    Fig 1: Identifying Screws And Blower Unit
    G04829766Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. INSTALL REAR NO. 1 AIR DUCT (for Cold Area Specification Vehicles) (See INSTALLATION  )
  8. INSTALL REAR NO. 2 AIR DUCT (for Cold Area Specification Vehicles) (See INSTALLATION  )
  9. INSTALL DEFROSTER NOZZLE ASSEMBLY (See INSTALLATION  )
  10. INSTALL HEATER TO REGISTER DUCT ASSEMBLY (See INSTALLATION  )
  11. INSTALL STEERING COLUMN ASSEMBLY  (See INSTALLATION )
  12. INSTALL BRAKE PEDAL SUPPORT SUB-ASSEMBLY (for Manual Transaxle)  (See INSTALLATION )
  13. INSTALL BRAKE MASTER CYLINDER PUSH ROD CLEVIS (for Manual Transaxle)  (See INSTALLATION )
  14. INSTALL BRAKE PEDAL (for Automatic Transaxle)  (See INSTALLATION )
  15. INSTALL STEERING SLIDING YOKE SUB-ASSEMBLY (See INSTALLATION  )
  16. INSTALL COLUMN HOLE COVER SILENCER SHEET  (See INSTALLATION )
  17. INSTALL INSTRUMENT PANEL SUB REINFORCEMENT  (See INSTALLATION )
  18. CONNECT POWER STEERING ECU  (See INSTALLATION )
  19. INSTALL COMBINATION SWITCH ASSEMBLY  (See INSTALLATION )
  20. INSTALL STEERING COLUMN COVER  (See INSTALLATION )
  21. INSTALL STEERING WHEEL ASSEMBLY  (See INSTALLATION )
  22. INSTALL STEERING PAD  (See INSTALLATION )
  23. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY  (See INSTALLATION )
  24. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY  (See INSTALLATION )
  25. CONNECT ANTENNA CORD SUB-ASSEMBLY  (See INSTALLATION )
  26. INSTALL INSTRUMENT PANEL BOX  (See INSTALLATION )
  27. INSTALL INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY  (See INSTALLATION )
  28. INSTALL INSTRUMENT PAD LOWER RH  (See INSTALLATION )
  29. INSTALL INSTRUMENT PAD LOWER LH  (See INSTALLATION )
  30. INSTALL REAR CONSOLE BOX ASSEMBLY  (See INSTALLATION )
  31. INSTALL CONSOLE BOX CARPET  (See INSTALLATION )
  32. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY  (See INSTALLATION )
  33. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY  (See INSTALLATION )
  34. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)  (See INSTALLATION )
  35. INSTALL COWL SIDE TRIM BOARD RH  (See INSTALLATION )
  36. INSTALL COWL SIDE TRIM BOARD LH  (See INSTALLATION )
  37. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY RH  (See INSTALLATION )
  38. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY LH  (See INSTALLATION )
  39. INSTALL FRONT DOOR SCUFF PLATE RH  (See INSTALLATION )
  40. INSTALL FRONT DOOR SCUFF PLATE LH  (See INSTALLATION )
  41. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY  (See INSTALLATION )
  42. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY  (See INSTALLATION )
  43. INSTALL FRONT PILLAR GARNISH RH  (See INSTALLATION )
  44. INSTALL FRONT PILLAR GARNISH LH  (See INSTALLATION )
  45. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH  (See INSTALLATION )
  46. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH  (See INSTALLATION )
  47. CONNECT AIR INLET DAMPER CONTROL CABLE SUB-ASSEMBLY (See INSTALLATION  )
  48. CONNECT DEFROSTER DAMPER CONTROL CABLE SUB-ASSEMBLY (See INSTALLATION  )
  49. CONNECT AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY (See INSTALLATION  )
  50. INSTALL AIR CONDITIONING PANEL ASSEMBLY (See INSTALLATION  )
  51. INSTALL STEREO OPENING COVER (w/o Radio Receiver)  (See INSTALLATION )
  52. INSTALL RADIO RECEIVER ASSEMBLY  (See INSTALLATION )
  53. INSTALL INSTRUMENT CLUSTER FINISH PANEL CENTER SUB-ASSEMBLY  (See INSTALLATION )
  54. INSTALL COMBINATION METER ASSEMBLY  (See INSTALLATION )
  55. INSTALL INSTRUMENT CLUSTER FINISH PANEL  (See INSTALLATION )
  56. INSTALL INSTRUMENT PANEL FINISH PANEL END RH  (See INSTALLATION )
  57. INSTALL INSTRUMENT PANEL FINISH PANEL END LH  (See INSTALLATION )
  58. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER  (See INSTALLATION )
  59. CONNECT HEATER WATER INLET HOSE (See INSTALLATION  )
  60. CONNECT HEATER WATER OUTLET HOSE (See INSTALLATION  )
  61. INSTALL LIQUID TUBE SUB-ASSEMBLY (See INSTALLATION  )
  62. INSTALL SUCTION TUBE SUB-ASSEMBLY (See INSTALLATION  )
  63. ADD ENGINE COOLANT (for 1NZ-FE)  (See REPLACEMENT )
  64. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

  65. CHECK SRS WARNING LIGHT 

    (See INSTALLATION  )

  66. CHARGE REFRIGERANT (See REPLACEMENT  )
  67. WARM UP ENGINE (See REPLACEMENT  )
  68. CHECK FOR ENGINE COOLANT LEAK (for 1NZ-FE)  (See ON-VEHICLE INSPECTION )
  69. CHECK FOR REFRIGERANT LEAK (See REPLACEMENT  )
  70. POSITION FRONT WHEELS FACING STRAIGHT AHEAD 
  71. PERFORM CALIBRATION OF TORQUE SENSOR ZERO POINT  (See INSTALLATION )
scientia non olet · About LEMON Manuals