COMBINATION METER (for Sedan): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL COMBINATION METER ASSEMBLY
1. Install the combination meter assembly with the 2 screws.
  NOTE: Install the meter by inserting the ribbed portions of the meter between the instrument panel and meter cluster.
2. Connect the 2 connectors.
  
  Fig 1: Identifying Combination Meter Assembly Connectors And Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INSTRUMENT CLUSTER FINISH PANEL
1. Fit the 2 claws of the instrument cluster finish panel into the upper instrument cluster finish panel center.
  
  Fig 2: Identifying Instrument Cluster Finish Panel Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Engage the 5 claws and 5 clips and install the instrument cluster finish panel.
  
  Fig 3: Identifying Instrument Cluster Finish Panel Claws And Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INSTRUMENT PANEL FINISH PANEL END RH
1. Engage the 6 claws and 3 clips and install the instrument panel finish panel end RH.
  
  Fig 4: Identifying Instrument Panel Finish Panel End RH Claws And Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INSTRUMENT PANEL FINISH PANEL END LH
1. Engage the 6 claws and 3 clips and install the instrument panel finish panel end LH.
  
  Fig 5: Identifying Instrument Panel Finish Panel End LH Claws And Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER
1. Engage the 2 claws and 2 clips and install the instrument panel finish panel lower center.
Fig 6: Identifying Instrument Panel Finish Panel Lower Center Claws And Clips
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)