Steering Pad: Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See AIRBAG SYSTEM ).

Fig 1: Removing Locking Button

INSTALL STEERING PAD
NOTE: Do not use a steering pad that has been dropped.
1. Confirm that the ignition switch is turned to OFF.
2. Confirm that the negative battery terminal is detached.
  CAUTION: Do not begin the operation for at least 90 seconds after the negative battery terminal is detached.
3. Connect the horn terminal.
4. Connect the airbag connector.
  NOTE:
  - Match the color of the airbag connector with that of the steering pad assembly and install the airbag connector.
  - Securely lock the locking button.
    
    Fig 2: Identifying Locking Button Installation Positions
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Install the steering pad.
6. Using "Torx" socked wrench T30, tighten the 2 bolts.
  Torque: 8.8 N*m (90 kgf*cm, 78 in.*lbf)
  
  NOTE: Tighten the 2 bolts while holding the steering pad to prevent it moving upward.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
INSPECT SRS WARNING LIGHT
(See DIAGNOSIS SYSTEM )

Fig 3: Locating Steering Pad Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002