Section 5 (Engine Mechanical <2.4L> - Lancer)
WARNING: This page is about a different variant/trim than selected.
- General Information
- Engine Diagnosis
- Service Specifications
- Sealants
- Special Tools
- On-Vehicle Service
- Crankshaft Pulley
- Camshaft
- Removal And Installation
- Notes
- Removal Service Points
- <<A>> Rocker Cover Assembly Removal
- <<B>> Number 1 Cylinder Compression Top Dead Center Setting
- <<C>> Camshaft And Camshaft Sprocket Assembly (Exhaust Side) Removal Preparatory Operation
- <<D>> Front Camshaft Bearing Cap Removal
- <<E>> Oil Feeding Camshaft Bearing Cap/Camshaft Bearing Cap/Thrust Camshaft Bearing Cap Removal
- <<F>> Camshaft And Camshaft Sprocket Assembly (Exhaust Side) Removal
- <<G>> Camshaft Sprocket/Camshaft Removal
- <<H>> Power Steering Oil Pump Assembly Removal
- <<I>> Oil Feeder Control Valve Removal
- Installation Service Points
- >>A<< O-Ring/Oil Feeder Control Valve Installation
- >>B<< Camshaft/Camshaft Sprocket Installation
- >>C<< Camshaft And Camshaft Sprocket Assembly (Intake Side) Installation
- >>D<< Thrust Camshaft Bearing Cap/Camshaft Bearing Cap/Oil Feeding Camshaft Bearing Cap/Camshaft Bearing Installation
- >>E<< Camshaft Bearing/Camshaft And Camshaft Sprocket Assembly (Exhaust Side) Installation
- >>F<< Front Camshaft Bearing Cap Installation
- >>G<< Rocker Cover Assembly Installation
- Removal And Installation
- Valve Stem Seal
- Removal And Installation
- Notes
- Removal Service Points
- Installation Service Points
- >>A<< Valve Stem Seal Installation
- >>B<< Valve Spring Retainer Lock Installation
- >>C<< Valve Tappet Installation
- >>D<< Thrust Camshaft Bearing Cap/Camshaft Bearing Cap/Oil Feeding Camshaft Bearing Cap Installation
- >>E<< Camshaft Bearing/Camshaft And Camshaft Sprocket Assembly (Exhaust Side) Installation
- >>F<< Front Camshaft Bearing Cap Installation
- Removal And Installation
- Oil Pan
- Crankshaft Oil Seal
- Cylinder Head Gasket
- Removal And Installation
- Notes
- Removal Service Points
- Installation Service Points
- >>A<< Cylinder Head Gasket/Cylinder Head Assembly Installation
- >>B<< Cylinder Head Bolt Assembly/Cylinder Head Bolt Installation
- >>C<< Camshaft Bearing/Camshaft And Camshaft Sprocket Assembly Installation
- >>D<< Thrust Camshaft Bearing Cap/Camshaft Bearing Cap/Oil Feeding Camshaft Bearing Cap Installation
- >>E<< Front Camshaft Bearing Cap Installation
- >>F<< Fuel High-Pressure Hose Connection
- >>G<< O-Ring Installation
- >>H<< Radiator Lower Hose/Radiator Upper Hose Connection
- Removal And Installation
- Timing Chain
- Balancer Timing Chain, Balancer Shaft And Oil Pump Module
- Balancer Shaft And Oil Pump Module
- Engine Assembly
- Removal And Installation
- Notes
- Removal Service Points
- <<A>> Radiator Upper Hose/Radiator Lower Hose Disconnection
- <<B>> Fuel High-Pressure Hose Disconnection
- <<C>> Power Steering Oil Pump Assembly Removal
- <<D>> A/C Compressor And Clutch Assembly Removal
- <<E>> Manual Transaxle Assembly <M/T >/CVT Assembly <CVT> Removal
- <<F>> Engine Mounting Insulator Removal
- <<G>> Engine Assembly Removal
- Installation Service Points
- Removal And Installation