LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Mechanical <2.4L> - Lancer) >> Crankshaft Oil Seal >> Removal And Installation >> Installation Service Points >> >>A<< Crankshaft Rear Oil Seal Installation

>>A<< Crankshaft Rear Oil Seal Installation

WARNING: This page is about a different variant/trim than selected.
  1. Apply a small amount of engine oil to the entire inner diameter of the crankshaft rear oil seal lip.
  2. Using special tool MD998718, press in the crankshaft rear oil seal up to the cylinder block end surface.
    Fig 1: Pressing Crankshaft Rear Oil Seal To Cylinder Block End Surface Using Special Tool MD998718
    G06671552Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals