LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Mechanical <2.4L> - Lancer) >> Timing Chain >> Removal And Installation >> Installation Service Points >> >>C<< Crankshaft Front Oil Seal Installation

>>C<< Crankshaft Front Oil Seal Installation

WARNING: This page is about a different variant/trim than selected.
  1. Apply a small amount of engine oil to the entire inner diameter of the crankshaft front oil seal lip.
    CAUTION: When installing the crankshaft front oil seal, be careful to avoid damage to the crankshaft front oil seal.
  2. Using special tool MB991448, press in the crankshaft front oil seal up to the chamfered surface of timing chain case.
    Fig 1: Pressing Crankshaft Front Oil Seal Using Special Tool MB991448
    G06671594Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals