Section 1 (Electrified Powertrain System (2 Of 2))
WARNING: This page is about a different car, the 2024 RAM ProMaster EV. However, it is still accessible from the selected car via links, so may be relevant.
- High Voltage Battery
- Description And Operation
- BEV High Voltage Battery
- Notes
- Description And Operation - High Voltage Battery
- Functional Description - Battery Pack Control Module (BPCM)
- Functional Description - Electric Vehicle Control Unit (EVCU)
- Functional Description - HVIL Circuit
- Functional Description - Instrument Panel Cluster (IPC)
- Functional Description - Power Inverter Module (PIM)
- Technical Data - System Architecture
- Battery Electric Vehicle (BEV) Charging
- BEV High Voltage Battery
- Standard Procedure
- BEV Vehicle Pushing Procedure
- High Voltage Safety Procedures
- MULTIMETER Setup For High Voltage Check
- Vehicle High Voltage Power Down
- High Voltage Power Up
- Internal HV Battery Module Isolation - Safe Mode
- Internal HV Battery Bus Bar Installation And Voltage Stack Up
- High Voltage Loss Of Isolation Test Procedure
- Pressure Testing The Battery Case And HV Battery Cooling System
- Resolver Relearn
- Specifications
- High Voltage Battery
- Cables
- Removal And Installation
- High Voltage Power Distribution Center (HVPDC) To Integrated Dual Charging Module (IDCM)
- Charge Port To High Voltage Battery Pack
- Charge Port Jumper Harness
- Battery Pack To Electric Drive Motor (EDM)
- High Voltage Power Distribution Center (HVPDC) To Electronic Air Conditioning Compressor (EAC)
- High Voltage Power Distribution Center (HVPDC) To Battery Coolant Heater (BCH)
- High Voltage Power Distribution Center (HVPDC) To Electric Cabin Heater (ECH)
- Removal And Installation
- Fuses
- Description And Operation
- Battery Cooling
- Park System