Install reinforcement strut
- Install the reinforcement strut (2) .
- Replace screws (1)
.
Parts: Screws
- Tighten the screws (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Reinforcement strut on upper front connection/bumper bracket | ||
|---|---|---|
| M8x20 screw Replace screws |
Tightening torque | 28 Nm |
Follow-up work
- Refer to INSTALLING WASHER FLUID RESERVOIR .
- Refer to INSTALLING THE FRONT MULTIFUNCTION FRAME .
- Refer to INSTALLING THE LEFT AND RIGHT HEADLIGHT .
- Refer to INSTALLING THE FRONT BUMPER COVER .
- Refer to INSTALLING THE FRONT ORNAMENTAL GRILLE/RADOME .
- Refer to INSTALLING THE FRONT RADIATOR GRILL FRAME .
- Refer to INSTALLING THE NUMBER PLATE BASEPLATE FOR THE LICENSE PLATE AT THE FRONT .
- Refer to INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
- Refer to ADJUSTING HEADLIGHTS .
- Refer to CLOSING THE ENGINE COMPARTMENT LID .
- Refer to PUTTING THE FRONT RADAR SENSORS INTO OPERATION .