Installing washer fluid reservoir

• Position the washer fluid reservoir (2)  and tighten the screws (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Join and connect the hose pipes (1)  .

  The hose pipes (1)  must snap in audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Lay the wiring harness correctly and clip it into the cable bracket (arrows).
• Connect connectors (1)  and lock.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect the connector (1)  and clip it into the cable bracket (2)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE FRONT MULTIFUNCTION FRAME .
• Refer to INSTALLING THE LEFT AND RIGHT HEADLIGHT .
• Refer to INSTALLING THE FRONT BUMPER COVER .
• Refer to INSTALLING THE FRONT ORNAMENTAL GRILLE/RADOME .
• Refer to INSTALLING THE NUMBER PLATE BASEPLATE FOR THE LICENSE PLATE AT THE FRONT .
• Refer to INSTALLING THE FRONT RADIATOR GRILL FRAME .
• Refer to INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
• Refer to ADJUSTING HEADLIGHTS .
• Refer to CLOSING THE ENGINE COMPARTMENT LID .
• Refer to PUTTING THE FRONT RADAR SENSORS INTO OPERATION .