Installing the front bumper cover
- Install bumper cover (1) and connect any existing connectors.
- Engage bumper cover (1)
into the detents in the area of the dotted lines.
- Engage bumper cover (1) into snap-in lugs (2) .
NOTE:
Perform the steps on the right and left side.
- Tighten the screws (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Bumper cover on side wall | ||
|---|---|---|
| Screw | Tightening torque | 3 Nm |
- Tighten the screws (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Bumper cover | ||
|---|---|---|
| Screw for thermoplastics | Tightening torque | 2.3 Nm |
NOTE:
Perform the steps on the right and left side.
- Connect and lock connector (1) in the wheel well.
- Activate the vehicle electrical system.
Follow-up work
- Refer to INSTALLING THE FRONT ORNAMENTAL GRILLE/RADOME .
- Refer to INSTALLING THE FRONT RADIATOR GRILL FRAME .
- Refer to INSTALLING THE NUMBER PLATE BASEPLATE FOR THE LICENSE PLATE AT THE FRONT .
- Refer to INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
- Refer to CLOSING THE ENGINE COMPARTMENT LID .
- Refer to PUTTING THE FRONT RADAR SENSORS INTO OPERATION .