Exterior Body Panels (Hood, Lids) (Service Information)

• (55 Hood, Lids)
  • Hood
    • Overview - Hood
      • Overview - Hood
      • Overview - Hood, Hood Latch
      • Overview - Hood, Gas-Filled Strut
    • Overview - Release Cable
    • Hood, Removing And Installing
      • Hood Impact Guard, Replacing
      • Hood Seal, Removing And Installing
    • Hood, Adjusting
    • Hood Latch, Removing And Installing
      • Removing
      • Installing
      • Tightening Specifications
    • Hood Release Lever, Removing And Installing
      • Release Lever Cover, Removing And Installing
      • Operating Lever, Removing And Installing
    • Catch, Removing And Installing
      • Hood Catch Bracket, Removing And Installing
        • Removing
        • Installing
        • Tightening Specifications
      • Lock Carrier Hooks, Removing And Installing
        • Removing
        • Installing
        • Tightening Specifications
      • Catch, Removing And Installing
    • Hinges, Removing And Installing
    • Insulation, Removing And Installing
    • Gas-Filled Strut, Removing And Installing
      • Removing
      • Installing
    • Gas-Filled Strut, Releasing Gas
      • Procedure
    • Release Cable, Removing And Installing
      • Release Cable Coupling
      • Attach the Release Cable into the Coupling
      • Release Cable, Engaging in Hood Lock
      • Engaging the Release Cable in Release Lever
  • Rear Lid
    • Overview - Rear Lid
      • Overview - Rear Lid
      • OVERVIEW - REAR LID, Rear Lid Motor 1 -V444-, MOTOR WITH WORM GEAR
    • Rear Lid, Adjusting
      • Notes
      • Adjusting Buffer, Adjusting
        • Notes
        • Adjustment Screw Or Buffer & Protective Cap
        • Stop Rear Lip Side
    • Rear Lid Latch, Removing And Installing
      • Rear Lid Latch, Removing And Installing
      • Rear Lid Latch Emergency Release
    • Actuator, Removing And Installing
      • Motor With Spindle Drive, Removing And Installing
      • Rear Lid Control Module -J605-, REMOVING AND INSTALLING
        • Removing
        • Installing
      • Coupling Rod Cover, Removing And Installing
        • Notes
        • Inner Cover, Unclipping From Coupling Rod
      • Rear Lid Drive Coupling Rod, Removing And Installing
        • Notes
        • Coupling Rod, Removing
      • Rear Lid Motor 1 -V444- AND Rear Lid Motor 2 -V445-, REMOVING AND INSTALLING
        • Notes
        • Plastic Bushing For Lever, Installing
        • Marking On The Tooth On The Motor Axle
        • Motor With Spindle Drive
        • Spindle Motor, Removing From Ball Stud
    • Hinges, Removing And Installing
      • Hinges, Removing And Installing
      • Replacing The Rear Lid Hinge Cover
    • Rear Lid Seal, Removing And Installing
    • Gas-Filled Strut, Removing And Installing
    • Gas-Filled Strut, Releasing Gas
      • Gas-Filled Strut, Disposing
  • Fuel Filler Door Unit
    • Overview - Fuel Filler Door Unit
    • Fuel Filler Door Unit, Removing And Installing
      • Fuel Filler Door, Removing And Installing
        • Notes
        • Fuel Filler Door, Removing
        • Fuel Filler Door, Installing
      • Fuel Filler Door Drain Hose
      • Fuel Filler Door Emergency Release
  • Special Tools