Hood Seal, Removing And Installing

Courtesy of AUDI OF AMERICA, LLC

Gasket for Plenum Chamber
- To remove, pull forward off the body flange.
- Mount the seal on the foam piece and then push it onto the flange on the body.
- Mount the seal on the opposite side on the foam piece and push it onto the flange on the body.
- Press the seal on the opposite side on the flange on the body using up any overlap.
Right Sealing Profile
- To remove, unclip it from the fender flange and the suspension strut tower.
- Press the clips on the foam piece into the body when installing.
Plenum Chamber Bulkhead
- Slide the plenum chamber seal on at the sides.