Replacing The Rear Lid Hinge Cover
- Clip
- Hinge Cover
- Self-adhesiveNOTE:
Make sure there is no dust or grease on the hinge cover adhesive surface.
Peel the protective film off the tape after installing the hinge cover.
- Removing
-- Remove the clip and the rear hinge cover.
- Installing
-- Install the hinge cover into the side wall frames. While doing this, the pins -arrow- on the cover -4- must fit into the eyes in the hinge cover.
-- Push the hinge cover upward over the right tab next to the rear lid hinge.
-- Push the side clips into the roof frame.
-- Peel off the protective film between the roof frame and the hinge cover.
-- Press the hinge cover on the roof frame using force.
- Self-adhesive
- Grommet
- Press into the side wall frame and roof frame.
- Cover
- Self-adhesive
- Lid Hinge