LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> RS 7 Base >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Exterior Body Panels (Hood, Lids) (Service Information) >> (55 Hood, Lids) >> Hood >> Hood Release Lever, Removing And Installing >> Operating Lever, Removing And Installing

Operating Lever, Removing And Installing

GWWA55-10711Courtesy of AUDI OF AMERICA, LLC
  1. Hood Release Lever Bracket
    • The hood release lever cover is removed.
    • The trim for the >>lower A-pillar is removed<<.
    • Remove the screws -3- and disengage the cable -1-.
  2. Clip
  3. Release Cable
    • Clip the cable bracket into the mounting bracket as shown in the magnified section of the illustration.
  4. Screws
    • 2 Nm
scientia non olet · About LEMON Manuals