Section 84 (Controls, Housing - Manual Transmission Internal Components 0B2 AWD (Coupe))
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi S5, 2015 Audi S5, 2014 Audi S5, 2013 Audi A5, and 2012 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
- 34 Controls, Housing
- Description And Operation
- Transmission Overview
- Transmission And Differential Housing Assembly Overview
- Center Differential Housing And Center Differential Assembly Overview
- Left Flange Shaft, Clutch Module, Side Shaft, Gearshift Shaft And Transmission Cover Assembly Overview
- Input Shaft, Output Shaft, Reverse Drive Gear And Shift Rails/Shift Forks Assembly Overview
- Specifications
- Disassembly And Assembly
- Transmission, Assembly Sequence
- Center Differential Housing
- Transmission Cover
- Notes
- Removing And Installing The Large Locking Bushing -1- On The Gearshift Shaft
- Installed Dimension For The Large Locking Bushing -1- Inside The Transmission Cover
- Installing The Needle Bearing All The Way Into The Transmission Cover
- Securing The Needle Bearing Inside The Transmission Cover By PEENING It
- Pressing Tapered Roller Bearing Outer Race Out From The Transmission Cover
- Installing The Outer Race / Tapered Roller Bearing All Way Into The Transmission Cover
- Removing The Input Shaft Roller Sleeve From The Transmission Cover
- Installing The Input Shaft Roller Sleeve -A- All The Way Into The Transmission Cover
- Removing And Installing The Gearshift Shaft Cover -A-
- Gearshift Shaft Cover Assembly Overview
- Assembly Overview - Gearshift Shaft Cover With A Hole -Arrow- For The Transmission Neutral Position Sensor -G701- Or Cap
- Gearshift Shaft Seal, Removing And Installing
- Removing The Gearshift Shaft Ball Sleeve From The Cover
- Installing The Gearshift Shaft Ball Sleeve -A- Evenly In The Cover -B-
- Installing The Gearshift Shaft Ball Sleeve -A- Up To Dimension -X- Into The Cover -B-,
- Removing The Bearing Bushing For The 3RD And 4TH Gear Gearshift Rail /. From The Transmission Cover
- Installing The Bearing Bushing -A- For The 3RD And 4TH Gear Gearshift Rail / Shift Fork All The Way Into The Transmission Cover
- Transmission Housing
- Notes
- Breather Pipe Installation Dimension
- Removing The Bearing Bushing For The Gearshift Rail / Shift Fork
- Installing The Bearing Bushing -Arrow- For The Gearshift Rail / Shift Fork
- Removing The Output Shaft Ball Bearing From The Transmission Housing
- Installing The Output Shaft Ball Bearing -A- In The Transmission Housing
- Installing The Input Shaft Ball Bearing -A- In The Transmission Housing
- Installed Position: Locking Rings -A- For The Ball Bearings -B-
- Gearshift Rails And Selector Forks
- Special Tools
- Description And Operation