Removing And Installing The Large Locking Bushing -1- On The Gearshift Shaft
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi S5, 2015 Audi S5, 2014 Audi S5, 2013 Audi A5, and 2012 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
- The gearshift shaft must be removed.
- If the transmission is not disassembled, place a cloth in the opening for the gearshift shaft to prevent the locking bushing from falling into the transmission.
-- Remove the large locking bushing using the T40085 toward the inside, in the transmission cover.
-- Install the locking bushing using the T40085 to the installation dimension INSTALLED DIMENSION FOR THE LARGE LOCKING BUSHING -1- INSIDE THE TRANSMISSION COVER .