Center Differential Housing: Notes
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi S5, 2015 Audi S5, 2014 Audi S5, 2013 Audi A5, and 2012 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Thrust Plate VW 401
- Thrust Plate VW 402
- Thrust Disc VW 412
- Tube 60 mm Dia. VW 415 A
- Press Tube 30 - 100
- Press Tube 2040
- Thrust Piece T40165
- Thread Locking Compound AMV 185 101 A1
- Sealing Grease G 052 128 A1
- Center Differential
- Service by manufacturer only
- Spring
- Adjustment Shim
- Plate Spring
- Installed position: the camber on the inner diameter faces toward the flange shaft
- Spacer Sleeve
- Securing Ring
- For flange shaft
- Removing and installing, refer to REMOVE THE CIRCLIP -ARROW-.
- Ball Bearing
- For flange shaft
- Removing INSTALLING THE FLANGE SHAFT BALL BEARING AND SPACER SLEEVE
- Installing REMOVING THE FLANGE SHAFT BALL BEARING AND SPACER SLEEVE
- Shaft Seal
- Prying out PRYING OUT THE SHAFT SEAL -1-
- Installing INSTALLING THE SEAL FOR THE REAR FLANGE SHAFT
- Rear Flange Shaft
- Without vibration damper
- Allocate components shims.
- Removing PRESSING OUT FLANGE SHAFT
- Installing PRESSING IN FLANGE SHAFT
- Rear Flange Shaft
- With vibration damper
- Allocate components shims.
- Removing PRESSING OUT FLANGE SHAFT
- Installing PRESSING IN FLANGE SHAFT
- Bolt
- 15 Nm plus an additional 90° turn
- For vibration damper
- Quantity: 3
- Insert with locking fluid AMV 185 101 A1
- Vibration Damper
- Not present on all versions
- Allocate according to transmission code.
- Center Differential Housing
- Removing and installing with transmission installed, refer to REMOVAL AND INSTALLATION