Gearshift Shaft Seal, Removing And Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi S5, 2015 Audi S5, 2014 Audi S5, 2013 Audi A5, and 2012 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
-- Pry out the shaft seal using the T20143/1.
-- Lightly oil outer circumference of shaft seal.
-- Fill area between sealing lip and dust lip halfway with sealing grease G 052 128 A1.
-- Install the shaft seal using the T10001/1 or the tube VW 423.
- Installed dimension: 2 mm under the upper edge of the cover