Antenna Feeder No. 3 Inspection

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Remove the rain sensor cover, (with auto light/wiper system). See RAIN SENSOR REMOVAL/INSTALLATION .
Disconnect the rain sensor connector, (with auto light/wiper system). See RAIN SENSOR REMOVAL/INSTALLATION .
Disconnect the auto-dimming mirror connector, (with auto-dimming mirror). See AUTO-DIMMING MIRROR REMOVAL . See AUTO-DIMMING MIRROR INSTALLATION .
Remove the following parts:
1. Sunroof seaming welt (with sunroof system)
2. A-pillar trim. See A-PILLAR TRIM REMOVAL/INSTALLATION .
3. Upper anchor of the front seat belt. See FRONT SEAT BELT REMOVAL/INSTALLATION .
4. Front scuff plate. See FRONT SCUFF PLATE REMOVAL/INSTALLATION .
5. Rear scuff plate. See REAR SCUFF PLATE REMOVAL/INSTALLATION .
6. B-pillar lower trim. See B-PILLAR LOWER TRIM REMOVAL/INSTALLATION .
7. B-pillar upper trim. See B-PILLAR UPPER TRIM REMOVAL/INSTALLATION .
8. Rear seat cushion. See REAR SEAT CUSHION REMOVAL/INSTALLATION .
9. Rear side seat back. See REAR SIDE SEAT BACK REMOVAL/INSTALLATION .
10. C-pillar trim. See C-PILLAR TRIM REMOVAL/INSTALLATION .
11. Map light. See MAP LIGHT REMOVAL/INSTALLATION .
12. Sunvisor. See SUNVISOR REMOVAL/INSTALLATION .
13. Assist handle. See ASSIST HANDLE REMOVAL/INSTALLATION .
14. Headliner. See HEADLINER REMOVAL/INSTALLATION .
Disconnect the antenna feeder No. 2

Fig 1: Identifying Antenna Feeder No. 2
Courtesy of MAZDA MOTORS CORP.
Verify that the continuity between antenna feeder No. 3 terminals is as indicated in the table.
- If not as indicated in the table, replace antenna feeder No. 3.
  
  Fig 2: Test Condition Terminal Chart
  Courtesy of MAZDA MOTORS CORP.
  
  Fig 3: Checking Continuity Between Antenna Feeder No. 3 Terminals
  Courtesy of MAZDA MOTORS CORP.