LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Sliding Roof) >> Sliding Roof Housing >> Removal

Sliding Roof Housing: Removal

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FRONT SEAT HEADREST ASSEMBLY 
  2. REMOVE FRONT OUTER SEAT TRACK BRACKET COVER LH  (See REMOVAL )
  3. REMOVE FRONT INNER SEAT TRACK BRACKET COVER LH  (See REMOVAL )
  4. REMOVE REAR OUTER SEAT TRACK BRACKET COVER LH  (See REMOVAL )
  5. REMOVE REAR INNER SEAT TRACK BRACKET COVER LH  (See REMOVAL )
  6. REMOVE FRONT SEAT ASSEMBLY LH  (See REMOVAL )
  7. REMOVE FRONT SEAT HEADREST ASSEMBLY 
  8. REMOVE FRONT OUTER SEAT TRACK BRACKET COVER RH 

    HINT

    Use the same procedure for the RH side and LH side

  9. REMOVE FRONT INNER SEAT TRACK BRACKET COVER RH 

    HINT.

    Use the same procedure for the RH side and LH side

  10. REMOVE REAR OUTER SEAT TRACK BRACKET COVER RH 

    HINT:

    Use the same procedure for the RH side and LH side

  11. REMOVE REAR INNER SEAT TRACK BRACKET COVER RH 

    HINT

    Use the same procedure for the RH side and LH side.

  12. REMOVE FRONT SEAT ASSEMBLY RH 

    HINT:

    Use the same procedure for the RH side and LH side

  13. REMOVE REAR SEAT CUSHION ASSEMBLY  (See REMOVAL )
  14. REMOVE REAR SEAT HEADREST ASSEMBLY LH 
  15. REMOVE REAR SEAT HEADREST ASSEMBLY RH 
  16. REMOVE REAR SEATBACK ASSEMBLY  (See REMOVAL )
  17. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD 
  18. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  19. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY  (See REMOVAL )
  20. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH  (See REMOVAL )
  21. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH  (See REMOVAL )
  22. REMOVE CONSOLE PANEL SUB-ASSEMBLY  (See REMOVAL )
  23. REMOVE FRONT ASH RECEPTACLE ASSEMBLY  (See REMOVAL )
  24. REMOVE REAR ASH RECEPTACLE ASSEMBLY  (See REMOVAL )
  25. REMOVE CONSOLE BOX REGISTER ASSEMBLY  (See REMOVAL )
  26. REMOVE CONSOLE BOX  (See REMOVAL )
  27. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY  (See REMOVAL )
  28. REMOVE CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL  (See REMOVAL )
  29. REMOVE MULTI-DISPLAY WITH RADIO RECEIVER ASSEMBLY (w/ Navigation System)  (See REMOVAL )
  30. REMOVE INTEGRATION CONTROL PANEL WITH RADIO RECEIVER ASSEMBLY (w/o Navigation System)  (See REMOVAL )
  31. REMOVE LOWER NO. 3 STEERING WHEEL COVER  (See REMOVAL )
  32. REMOVE LOWER NO. 2 STEERING WHEEL COVER  (See REMOVAL )
  33. REMOVE STEERING PAD  (See REMOVAL )
  34. REMOVE STEERING WHEEL ASSEMBLY  (See REMOVAL )
  35. REMOVE STEERING COLUMN COVER  (See REMOVAL )
  36. REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY  (See REMOVAL )
  37. REMOVE FRONT DOOR SCUFF PLATE LH  (See REMOVAL )
  38. REMOVE FRONT DOOR SCUFF PLATE RH 

    HINT:

    Use the same procedure for the RH side and LH side.

  39. REMOVE FRONT DOOR OPENING TRIM COVER LH  (See REMOVAL )
  40. REMOVE FRONT DOOR OPENING TRIM COVER RH 

    HINT:

    Use the same procedure for the RH side and LH side.

  41. REMOVE FRONT PILLAR GARNISH LH  (See REMOVAL )
  42. REMOVE FRONT PILLAR GARNISH RH 

    HINT:

    Use the same procedure for the RH side and LH side

  43. REMOVE SIDE INSTRUMENT PANEL LH  (See REMOVAL )
  44. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  (See REMOVAL )
  45. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY  (See REMOVAL )
  46. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY  (See REMOVAL )
  47. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY  (See REMOVAL )
  48. REMOVE COMBINATION METER ASSEMBLY  (See REMOVAL )
  49. REMOVE SIDE INSTRUMENT PANEL RH  (See REMOVAL )
  50. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  (See REMOVAL )
  51. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY  (See REMOVAL )
  52. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY  (See REMOVAL )
  53. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY  (See REMOVAL )
  54. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY  (See REMOVAL )
  55. REMOVE NO. 3 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY  (See REMOVAL )
  56. REMOVE FRONT STEREO COMPONENT SPEAKER ASSEMBLY (w/ Front Center Speaker)  (See REMOVAL )
  57. REMOVE NO. 2 CONSOLE BOX DUCT  (See REMOVAL )
  58. REMOVE NO. 1 CONSOLE BOX DUCT  (See REMOVAL )
  59. DISCONNECT INSTRUMENT PANEL WIRE ASSEMBLY  (See REMOVAL )
  60. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY  (See REMOVAL )
  61. REMOVE INSTRUMENT PANEL CLIP  (See REMOVAL )
  62. REMOVE INSTRUMENT PANEL STAY  (See REMOVAL )
  63. REMOVE NO. 2 FLOOR UNDER COVER  (See REMOVAL )
  64. REMOVE NO. 1 FLOOR UNDER COVER  (See REMOVAL )
  65. REMOVE TAIL EXHAUST PIPE ASSEMBLY  (See REMOVAL )
  66. REMOVE REAR NO. 1 FLOOR PANEL BRACE  (See REMOVAL )
  67. REMOVE FRONT CENTER FLOOR BRACE  (See REMOVAL )
  68. DISCONNECT HEATED OXYGEN SENSOR  (See REMOVAL )
  69. REMOVE FRONT EXHAUST PIPE ASSEMBLY  (See REMOVAL )
  70. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR  (See REMOVAL )
  71. REPAIR FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY  (See DISASSEMBLY )
  72. REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY  (See REMOVAL )
  73. REMOVE REAR DOOR SCUFF PLATE LH  (See REMOVAL )
  74. REMOVE REAR DOOR SCUFF PLATE RH 

    HINT:

    Use the same procedure for the RH side and LH side

  75. REMOVE LAP BELT OUTER ANCHOR COVER LH  (See REMOVAL )
  76. SEPARATE FRONT SEAT OUTER BELT ASSEMBLY LH  (See REMOVAL )
  77. REMOVE LOWER CENTER PILLAR GARNISH LH  (See REMOVAL )
  78. REMOVE CENTER PILLAR GARNISH LH  (See REMOVAL )
  79. REMOVE FRONT SEAT BELT ANCHOR COVER SUB-ASSEMBLY  (See REMOVAL )
  80. REMOVE LOWER CENTER PILLAR GARNISH RH 

    HINT:

    Use the same procedure for the RH side and LH side.

  81. SEPARATE FRONT SEAT OUTER BELT ASSEMBLY RH  (See REMOVAL )
  82. REMOVE CENTER PILLAR GARNISH RH 

    HINT:

    Use the same procedure for the RH side and LH side.

  83. REMOVE REAR SEAT SIDE GARNISH LH  (See REMOVAL )
  84. REMOVE REAR SEAT SIDE GARNISH RH 

    HINT

    Use the same procedure for the RH side and LH side.

  85. REMOVE ROOF SIDE INNER GARNISH LH  (See REMOVAL )
  86. REMOVE ROOF SIDE INNER GARNISH RH 

    HINT.

    Use the same procedure for the RH side and LH side.

  87. REMOVE INNER REAR VIEW MIRROR STAY HOLDER COVER  (See REMOVAL )
  88. REMOVE RAIN SENSOR  (See REMOVAL )
  89. REMOVE MAP LIGHT ASSEMBLY  (See REMOVAL )
  90. REMOVE SPOT LIGHT ASSEMBLY  (See ROOM LIGHT )
  91. REMOVE COAT HOOK  (See REMOVAL )
  92. REMOVE ASSIST GRIP SUB-ASSEMBLY  (See REMOVAL )
  93. REMOVE VISOR BRACKET COVER  (See REMOVAL )
  94. REMOVE VISOR ASSEMBLY LH  (See REMOVAL )
  95. REMOVE VISOR ASSEMBLY RH 

    HINT:

    Use the same procedure for the RH side and LH side.

  96. REMOVE VISOR HOLDER  (See REMOVAL )
  97. REMOVE ROOF HEADLINING ASSEMBLY  (See REMOVAL )
  98. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH  (See REMOVAL )
  99. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH 

    HINT.

    Use the same procedure for the RH side and LH side.

  100. REMOVE SLIDING ROOF SIDE GARNISH LH 
    1. Disengage the 5 claws and remove the sliding roof side garnish LH.
    Fig 1: Identifying Sliding Roof Side Garnish LH And Claws
    G05755894Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  101. REMOVE SLIDING ROOF SIDE GARNISH RH 

    HINT:

    Use the same procedure for the RH side and LH side.

  102. REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY 
    1. Using a T25 "TORX" socket wrench, remove the 4 screws and sliding roof glass sub-assembly.
    Fig 2: Identifying Sliding Roof Glass Sub-Assembly And Screws
    G05755895Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  103. REMOVE SLIDING ROOF HOUSING SUB-ASSEMBLY 
    1. Disconnect the 4 sliding roof drain hoses.
    2. Remove the 6 bolts, 8 nuts, and sliding roof housing sub-assembly.
      Fig 3: Identifying Sliding Roof Housing Sub-Assembly And Bolts
      G05755896Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  104. REMOVE SLIDING ROOF WEATHERSTRIP 
    1. Remove the sliding roof weatherstrip from the sliding roof glass sub-assembly.
scientia non olet · About LEMON Manuals