Rain Sensor: Removal

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE RAIN SENSOR
1. Release the stopper by pulling it down
  
  Fig 1: Releasing Stopper
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the connector and remove the rain sensor as shown in the illustration.
CLEAN WINDSHIELD GLASS
NOTE:
- The rain sensor tape can be reused, however, replace it with a new one if it has dirt on it or it is damaged.
- Check that the rain sensor tape does not remain on the windshield glass. If it does, remove it before installing the rain sensor.
  
  Fig 2: Removing Rain Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002