Section 12 (Four-Wheel Drive Systems - Advanced 4X4 With 4A Mode - Manual)
WARNING: This page is about a different variant/trim than selected.
- Description And Operation
- Diagnosis And Testing
- Four-Wheel Drive Systems
- Diagnostic Trouble Code (DTC) Chart
- Global Customer Symptom Code (GCSC) Chart
- Symptom Chart
- Symptom Chart -- NVH
- Pinpoint Tests
- Pinpoint Test A: P1001, P1397, P1501, P1705
- Pinpoint Test B: Module Configuration Faults
- Pinpoint Test C: AWD Module Power, Ground, Or Internal Fault
- Pinpoint Test D: Transfer Case Clutch Actuator
- Pinpoint Test E: C05E0:1C, C05E0:86
- Pinpoint Test F: Lost Communication With Another Module
- Pinpoint Test G: Invalid Data Received From Another Module
- Pinpoint Test H: Incorrect Torque Transferred To Front Axle After Installing Transfer Case
- Pinpoint Test I: The Transfer Case Does Not Transfer Torque Correctly
- Pinpoint Test J: C05D9:44
- Pinpoint Test K: C068F:17, C068F:34, C068F:35, C068F:36, C068F:37, C068F:49, C068F:94, C068F:96, C068F:A3
- Pinpoint Test L: C0688:09, C0688:11, C0688:12, C0688:19, C0688:1D, C0688:72, C0688:74, C0688:A2
- Pinpoint Test M: The Transfer Case Does Not Transfer Torque Correctly
- Pinpoint Test N: The Transfer Case Does Not Transfer Torque Correctly
- Pinpoint Test O: The Transfer Case Does Not Transfer Torque Correctly
- Pinpoint Test P: Fluid Leak From Transfer Case
- Pinpoint Test Q: Fluid Leak From Transfer Case
- Pinpoint Test R: Fluid Leak From Transfer Case
- Pinpoint Test S: Front Axle Binding On Sharp Turns On Dry Pavement
- Pinpoint Test T: 4WD Temporarily Locked Message Displayed
- Pinpoint Test U: 4WD Temporarily Locked Message Displayed
- Pinpoint Test V: Clicking/Whirring Noise From Transfer Case At Start Up
- Pinpoint Test W: The Transfer Case Makes Noise
- All Terrain Control Module (ATCM)
- Four-Wheel Drive Systems
- General Procedures
- Removal And Installation